mirror of
git://git.openembedded.org/meta-openembedded
synced 2026-09-16 22:01:23 +00:00
1d47796fcf
The bcu command can be used to communicate with board control hardware on NXP EVK development boards to: - reset / power cycle the board into a specified boot mode. - monitor the power consumption. - read / write the eeprom content. - measure temperatures. - etc. Supported boards are e.g.: - i.MX8MP-EVK - i.MX8DXL-EVK - i.MX8ULP-EVK - i.MX93-EVK The tool can either be built for the target architecture to control a board from a system running Yocto (less common) or for the host architecture to run it via `oe-run-native bcu-native bcu`. Signed-off-by: Leonard Göhrs <l.goehrs@pengutronix.de> Signed-off-by: Khem Raj <raj.khem@gmail.com>